Beverage Fountains Operating Instructions

Sizes: 4, 5 and 7 gallons

1. Pour approximately two quarts of beverage in lower and top reservoir and turn switch to *on.*

2. If beverage does not circulate within one minute, turn switch off for 10 seconds. Repeat this procedure several times until beverage flows freely.

3. After use, empty out remaining beverages and fill lower reservoir with two gallons of warm water and let circulate for five minutes. Empty the unit and repeat.


Do not run fountain dry. Do not immerse base of fountain in water. Do not use scouring pads or any type of abrasive cleanser on this unit for cleaning. Please do not take unit apart.

Helpful Hints:

* Beverage Fountains are designed to circulate clear beverages. Use of beverages with pulp, seeds, fruit, rinds, etc. will restrict the flow of beverage and may give unsatisfactory results. Use of ice cream or other foamy punches may also restrict the flow of the beverage.

* To chill beverage, use chunks of ice in the lower reservoir. To avoid dilution, place ice in plastic bags in the fountain.

* Pre-cool beverages whenever possible to at least 36 degrees before adding to the fountain.

* Carbonation will dissipate after 10-20 minutes of circulating in the fountain. It is advisable to add smaller quantities of mixtures to the fountain from time to time to maintain carbonation.

\For any questions or concerns, please contact us immediately.


Return to Main Instruction Page